Audiotek AT-SPW16GA/100RG 16-Gauge 100-Ft Speaker Wire

The Audiotek AT-SPW16GA/100RG is a 100-foot roll of 16-gauge speaker wire for running audio signals between amplifiers or receivers and speakers. It provides bulk cable for installations where factory wiring is being replaced, extended, or routed to new speaker locations. The red and clear conductors help identify polarity during installation.

This wire is intended for vehicle speaker wiring and can also be used for compatible home audio speaker connections. Its 100-foot length gives installers flexibility for multi-speaker layouts, longer vehicle runs, and custom routing. It is supplied as un-terminated cable, allowing the installer to cut each run to the required length.

With a 16 AWG rating, the AT-SPW16GA/100RG is sized for general speaker-level signal wiring. Correct wire selection depends on the length of the run, speaker load, and amplifier or receiver requirements. Using clearly identified positive and negative conductors supports consistent speaker polarity throughout the system.

The cable uses a clear PVC jacket with red and clear internal conductors. The jacket is described as flexible and resistant to heat, oil, and abrasion for routing through automotive interiors and other installation environments. Its multi-strand construction is designed to make the cable easier to handle than a solid-core speaker wire.

The AT-SPW16GA/100RG fits into a car-audio upgrade as the connection path between an aftermarket head unit or amplifier and the speakers. It can be used when adding replacement door speakers, component systems, rear-fill speakers, or a separate amplified speaker stage. Match the installation method and termination hardware to the equipment being connected.

Key Features

• 16-Gauge Wire: Provides a dedicated speaker-wire size for general audio installations.
• 100-Foot Length: Supports custom-cut runs across larger installation areas.
• Red/Clear Conductors: Helps identify polarity while wiring speakers.
• Clear PVC Jacket: Protects the paired conductors during routing and handling.
• Multi-Strand Construction: Supports flexible routing through vehicle interiors and panels.
• CCA Conductor Design: Uses copper-clad aluminum conductors for audio wiring applications.

Design & Installation

The AT-SPW16GA/100RG uses paired red and clear conductors inside a transparent PVC outer jacket. The jacket is described as durable, flexible, and resistant to heat, oil, and abrasion. This design keeps the cable identifiable during routing while helping protect the conductors from normal installation wear.

Measure each speaker run before cutting and leave enough length for service access and clean routing. Keep positive and negative connections consistent from the source to each speaker, using the red/clear conductor identification as your reference. Select terminals, adapters, loom, and mounting hardware separately as needed for the vehicle and equipment.