Memphis SE210 Dual 10" Ported Bass Package With Amplifier

The Memphis SE210 is a complete bass package built around a dual 10-inch loaded enclosure and a matching SE2000.1DF mono amplifier. It is designed for vehicle owners who want to add dedicated low-frequency output without selecting separate subwoofers, enclosure, and amplifier components. The package brings together the primary bass components in a coordinated system.

Its ported enclosure is intended to support strong bass output from the two Street Edge 10-inch subwoofers. Polypropylene cones and rubber surrounds provide the woofer assembly, while the enclosure is finished with Custom Street Edge embroidery. This makes the SE210 a practical choice for adding bass reinforcement to a factory or aftermarket audio system.

Each included woofer uses a 1.5-inch copper voice coil and a 27-ounce magnet. Memphis Direct Vent Voice Coil Cooling technology is used to help manage voice-coil heat during operation. The dual-subwoofer assembly is rated at 400 watts RMS and 800 watts peak power.

The included SE2000.1DF mono amplifier provides selectable power capability based on the connected impedance load. It is rated for up to 500 watts RMS and 1,000 watts peak at 1 ohm, with lower power ratings at 2 and 4 ohms. Its frequency response, low-pass crossover, and subsonic filter are designed specifically for subwoofer-duty use.

The SE210 is suited to trunk, cargo-area, or behind-seat installations where its enclosure dimensions fit securely. It can be used with an aftermarket receiver or a factory system when the appropriate signal integration is added. A separate amplifier wiring kit and enclosure-to-amplifier speaker wire are required for installation.

Key Features

• Dual 10-Inch Subwoofers: Two loaded Street Edge woofers provide dedicated bass output.
• Ported Enclosure: The enclosure is ported to support efficient bass performance.
• Included Mono Amplifier: A SE2000.1DF amplifier is supplied with the package.
• Polypropylene Cones: SE-branded polypropylene cones form each woofer diaphragm.
• DVVC Cooling: Direct Vent Voice Coil Cooling helps manage voice-coil heat.
• Remote Level Control: A wired remote level control is included.

Design & Installation

The enclosure uses heavy-duty MDF construction and carpet covering with Custom Street Edge embroidery. Its two woofers use rubber surrounds, 1.5-inch copper voice coils, and 27-ounce magnets. The ported cabinet measures 24.6 inches wide by 11 inches high, with 8.7-inch top depth and 10.6-inch bottom depth.

Mount the enclosure securely in a suitable vehicle cargo area and mount the amplifier where it has adequate ventilation. The package includes the enclosure, amplifier, remote level control, remote cable, mounting screws, and amplifier fuses, but it does not include an amplifier wiring kit or speaker wire between the amplifier and enclosure. A 4-gauge power and ground wiring kit with a 60-amp fuse is recommended for installation.