AUDIO360 AD0C 0 AWG Amplifier Wiring Kit

The AUDIO360 AD0C is a 0 gauge amplifier wiring kit for installing a high-current car audio amplifier system. It combines the primary power, ground, signal, remote-turn-on, and speaker wiring needed for a single installation package. This helps simplify system planning when upgrading an amplifier and subwoofer or speaker setup.

Its True Spec 0 AWG power cable is intended for amplifier installations that require a large-gauge main power run from the vehicle battery. The kit includes a 17-foot power cable and a 3-foot ground cable to support typical front-battery vehicle layouts. Cable lengths should still be checked against the vehicle's intended routing before installation.

For signal connection, the AD0C includes a 17-foot double-shielded RCA cable designed to carry audio from a compatible source unit to an amplifier. The shielding is intended to help reduce the chance of noise entering the low-level audio signal. A separate 17-foot remote turn-on wire is included for amplifier activation from a compatible head unit or signal source.

Protection is handled by an inline ANL fuse holder supplied with 200A and 250A ANL fuses. This provides two fuse-rating options, allowing the installer to use the rating appropriate for the amplifier system's documented electrical requirements. The fuse holder should be installed in the main power run according to safe vehicle-audio installation practices.

The kit also supplies 20 feet of speaker wire plus installation accessories such as terminals and hardware. It is intended for use across a broad range of vehicle types, including cars, trucks, SUVs, motorcycles, ATVs, and RVs. The AD0C is a practical foundation for a wired amplifier installation where the system does not already include its required cabling and protection components.

Key Features

• True Spec 0 AWG Power Cable: Provides a large-gauge main power connection for amplifier installations.
• 17-Foot Power Cable: Supports many vehicle battery-to-amplifier routing paths.
• ANL Fuse Holder: Adds inline circuit protection to the main power connection.
• Two Included Fuse Ratings: Includes 200A and 250A ANL fuse options.
• Double-Shielded RCA Cable: Helps keep the amplifier signal connection organized and protected from interference.
• Complete Installation Wiring: Includes power, ground, RCA, remote, speaker wire, and accessories.

Design & Installation

The AD0C centers on a green True Spec 0 AWG power cable, paired with separate ground, RCA, remote, and speaker wiring. Its ANL fuse holder, selectable fuse ratings, terminals, and installation accessories are supplied to consolidate common amplifier-installation components. This package is designed as an installation kit rather than an amplifier, speaker, or signal processor.

Route the 17-foot power cable from the battery to the amplifier while keeping it protected from abrasion, heat, and moving components. Use the 3-foot ground cable for a short, secure chassis ground near the amplifier, and route RCA signal cable separately from power wiring where practical. Confirm fuse selection, amplifier connection requirements, wire routing, and vehicle-specific mounting locations before beginning installation.