{"product_id":"cerwin-vega-cvp1400-4-4-channel-class-d-car-amplifier","title":"Cerwin Vega CVP1400.4 4-Channel Class D Car Amplifier","description":"\u003cp\u003eThe Cerwin Vega CVP1400.4 is a compact four-channel Class D car amplifier designed to add dedicated power to a factory or aftermarket audio system. It is suited to powering front and rear speakers, component sets, or two bridged speaker channels where a system calls for higher output. Its small chassis helps address installations where conventional amplifiers may be difficult to place.\u003c\/p\u003e\u003cp\u003eRated for 80 watts RMS per channel at 4 ohms and 140 watts RMS per channel at 2 ohms, the CVP1400.4 provides a practical power range for many car-audio speakers. It can also be bridged to deliver 290 watts RMS to each of two 4-ohm loads. This flexibility allows the amplifier to serve as a four-speaker amplifier or as part of a more focused two-channel system.\u003c\/p\u003e\u003cp\u003eClass D operation supports efficient power delivery in a compact enclosure. The amplifier uses a full MOSFET DC-DC PWM power supply, a double-sided two-layer circuit board, and surface-mount-device technology. Its frequency response extends from 10 Hz to 30 kHz, supporting full-range speaker applications.\u003c\/p\u003e\u003cp\u003eIntegration is supported through both low-level and high-level input capability. The high-level input includes auto turn-on operation for compatible 4V to 8V speaker-level signals, helping the amplifier work with many factory radios without requiring a separate line-output converter. Variable high-pass and low-pass filters allow each channel pair to be configured for the connected speakers.\u003c\/p\u003e\u003cp\u003eThe CVP1400.4 is a useful upgrade path for listeners who want more headroom and control than a radio's built-in amplifier can provide. It supports 2-ohm stereo loads and 4-ohm bridged loads, so speaker selection and wiring should be planned around those minimum impedances. Built-in protection provisions help safeguard the amplifier against short-circuit, low-impedance, reverse-polarity, and overheating conditions.\u003c\/p\u003e\u003ch3\u003eKey Features\u003c\/h3\u003e\u003cul\u003e\n\u003cli\u003e\n\u003cstrong\u003eFour-Channel Class D Design:\u003c\/strong\u003e Powers up to four speakers from a compact amplifier chassis.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003e80W x 4 RMS at 4 Ohms:\u003c\/strong\u003e Provides dedicated full-range power for compatible speakers.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003e2-Ohm Stable Stereo Operation:\u003c\/strong\u003e Delivers up to 140W RMS per channel at 2 ohms.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eBridgeable Channel Pairs:\u003c\/strong\u003e Supports 290W RMS x 2 into 4-ohm bridged loads.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eHigh-Level Inputs with Auto Turn-On:\u003c\/strong\u003e Helps integrate the amplifier with compatible factory radio outputs.\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eVariable HPF and LPF:\u003c\/strong\u003e Lets you tailor frequency range to the speakers being used.\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch3\u003eDesign \u0026amp; Installation\u003c\/h3\u003e\u003cp\u003eThe CVP1400.4 uses a compact 7.28-inch by 4.92-inch by 1.93-inch chassis. Its construction includes a full MOSFET DC-DC PWM power supply, double-sided two-layer PCB, and SMD technology. Power and protection indicators provide operating-status feedback, while the protection system addresses short circuit, low impedance, reverse polarity, and overheating conditions.\u003c\/p\u003e\u003cp\u003eMount the amplifier on a solid surface with adequate ventilation and access to the side-panel controls. Use 2-ohm-or-higher stereo speaker loads or 4-ohm-or-higher bridged loads, and configure the high-pass or low-pass filters to suit the speakers. The manual specifies a negative-ground 12V DC vehicle electrical system, recommends a minimum of 8 AWG power and ground wiring, and states that the terminals accept up to 4 AWG cable.\u003c\/p\u003e","brand":"Cerwin Vega","offers":[{"title":"Default Title","offer_id":45614312128582,"sku":"CER-CVP1400-4","price":196.96,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0048\/4163\/5910\/files\/51Eu2usVBSL.jpg?v=1784365745","url":"https:\/\/audiowatt.store\/products\/cerwin-vega-cvp1400-4-4-channel-class-d-car-amplifier","provider":"Audio Watt Store","version":"1.0","type":"link"}